LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Accessory Power Receptacle Replacement - 12 Volt >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the 12 volt power supply retainer with the key to the slot into the 12 volt power supply hole.
    Fig 1: Positioning Power Supply Retainer
    G01517749Courtesy of GENERAL MOTORS CORP.
  2. Install the 12 volt power supply retainer pressing into place until fully seated.
    Fig 2: Installing Power Supply Retainer
    G01517750Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the instrument panel 12 volt power supply.
    Fig 3: Connecting Electrical Connector To Instrument Panel Power Supply
    G01517751Courtesy of GENERAL MOTORS CORP.
  4. Position the 12 volt power supply to the retainer.
    Fig 4: Positioning Power Supply To Retainer
    G01517752Courtesy of GENERAL MOTORS CORP.
  5. Install the 12 volt power supply into the instrument panel pressing into place until fully seated.
  6. Install the 12 volt power supply fuse.
  7. Inspect the 12 volt power supply for proper operation.
    Fig 5: Installing Power Supply Into Instrument Panel
    G01517753Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals