TFP Manual Valve Position Switch (4T65-E): Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing the TFP switch handle the switch carefully, the fluid pressure manual valve position switch is very delicate.
- Carefully install the fluid pressure manual valve position switch (395). See Figure . Install the control valve body bolts (375, 379, 381) that mount the fluid pressure manual valve position switch to the control valve body (300).
- Tighten the control valve body bolt (375) to 106 INCH lbs. (12 N.m). Tighten the control valve body bolt (379) to 106 INCH lbs. (12 N.m).
- Tighten the control valve body bolt (381) to 70 INCH lbs. (8 N.m). Connect the transaxle wiring harness. Install the case side cover. See CASE SIDE COVER (4T65-E) .