LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission Servicing) >> Removal & Installation >> Lower Control Valve Body Assembly (4T80-E) >> Installation

Lower Control Valve Body Assembly (4T80-E): Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the lower controls assembly over the forward support studs. The bolts (958) without the flange are located next to the oil transfer plate. See Figure .
  2. Hand start the bolts into the channel plate. Install the 2 nuts (955) on the forward support studs. Place the oil transfer plate (956) over the open gasket area. See Figure .
  3. Position the lower control valve body wire harness retaining clips (943). See Figure .
  4. Hand start the bolts (534) to hold the oil transfer plate (956) in place with the lower control valve body wire harness retaining clips (943) attached properly. See Figure . Tighten the bolts and nuts (534) to 6-10 ft. lbs. (8-14 N.m).
scientia non olet · About LEMON Manuals