LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission Servicing) >> Removal & Installation >> Left Transaxle Mount & Bracket >> Installation

Left Transaxle Mount & Bracket: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply thread lock compound (GM P/N 12345493) or equivalent, to the 4 bolts that secure the left transaxle mount bracket to the case side cover.
  2. Install the left transaxle mount bracket (1) to the case side cover. See Figure . Tighten the 4 left transaxle mount bracket bolts to specification. See TORQUE SPECIFICATIONS  . Insert the mount stud into the transaxle mount bracket.
  3. Push up on the frame rail bolts in order to clear the mount (2) as the mount is rotated into the proper position. See Figure . Make sure the loose frame rail bolts are properly aligned with and inserted into the mount.
  4. Lower the vehicle. Install the frame rail bolt retaining screws. See Figure . Tighten the frame rail bolt retaining screws to specification. See TORQUE SPECIFICATIONS  . Raise the vehicle.
  5. Install the mount bolt (1) and rotate counter clockwise to ensure anti-rotation tab locks behind mount bracket. See Figure . Install the mount nuts (3) and (4). Tighten the mount nuts (3) and (4) to specification. See TORQUE SPECIFICATIONS  .
  6. Using the transaxle stand, raise the powertrain and load the mount. Install the mount stud nut onto the mount stud. Tighten the mount stud nut to specification. See TORQUE SPECIFICATIONS  .
  7. Remove the transaxle stand. Install the left fascia extension. Install the left front tire and wheel. Lower the vehicle.
scientia non olet · About LEMON Manuals