LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Pull the rear side hood seal from the pinch-weld flange and motor compartment flange.
  3. Remove the rear side hood seal from the vehicle.
  4. Clean any adhesive from the pinch-weld flange and motor compartment flange surface.
scientia non olet · About LEMON Manuals