LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Transmission Oil Cooler Line Quick Connect Fitting >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disengage the plastic cap from the quick connect fitting. Pull the plastic cap back along the pipe.
  2. Hold one leg of the retaining clip.
  3. Using a small pick-type tool or bent screwdriver, gently disengage the other end of the retaining clip from the quick connect fitting.
  4. Rotate the retaining clip out of the quick connect fitting. Remove the retaining clip completely.
    Fig 1: Removing Transmission Oil Cooler Line Quick Connect Fitting (1 Of 2)
    G01502040Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the cooler line from the quick connect fitting.
    Fig 2: Removing Transmission Oil Cooler Line Quick Connect Fitting (2 Of 2)
    G01502041Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals