LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Oil Pressure Test Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct.
  2. Remove the pressure test hole plug (38).
    Fig 1: Removing Oil Pressure Test Plug
    G01501946Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals