LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Automatic Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transaxle mount to the transaxle mount frame bracket.
  2. Install the transaxle mount lower nuts to the transaxle mount frame bracket.

    Tighten 

    Tighten the transaxle mount lower nuts to 47 N.m (35 lb ft).

  3. Install the transaxle mount bracket to the transaxle. Refer to AUTOMATIC TRANSMISSION MOUNT BRACKET REPLACEMENT  .
    Fig 1: Installing Transaxle Mount From Transaxle Mount Frame Bracket
    G01502050Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals