LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Accumulator & 2-1 Manual Servo Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the manual 2-1 band servo cover gasket (105) into the case. Lubricate the manual 2-1 band servo cover gasket with automatic transmission fluid.
  2. Install the manual 2-1 band servo (106-116).
    Fig 1: Installing Accumulator And 2-1 Manual Servo (1 Of 3)
    G01501963Courtesy of GENERAL MOTORS CORP.
  3. Install the manual 2-1 band servo cover (104).
  4. Install the manual 2-1 band servo cover bolts (103).

    Tighten 

    Tighten the manual 2-1 band servo cover bolts (130) to 25 N.m (18 lb ft).

  5. Install the accumulator (132).
  6. Install the lube oil pipe (130) into the case at the lube hole for the front differential carrier internal gear.
  7. Use a flat-bladed tool in order to lock the lube oil pipe retainer (129) into the case.
    Fig 2: Installing Accumulator And 2-1 Manual Servo (2 Of 3)
    G01501964Courtesy of GENERAL MOTORS CORP.
  8. Install the accumulator cover bolts (131).

    Tighten 

    Tighten the accumulator cover bolts (131) to 12 N.m (106 Ib. in).

  9. If removed, install a new filter seal.
  10. Install the filter. Refer to OIL FILTER AND SEAL REPLACEMENT  .
  11. Install the oil pan. Refer to OIL PAN REPLACEMENT  .
  12. Lower the vehicle.
    Fig 3: Installing Accumulator And 2-1 Manual Servo (3 Of 3)
    G01501965Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals