LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 870 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to ENGINE FLYWHEEL REPLACEMENT  .

    Important:  Do not damage the crankshaft or seal bore.

  2. Remove the crankshaft rear oil seal. Pry the crankshaft rear oil seal out using a suitable tool.
    Fig 1: Removing Crankshaft Rear Oil Seal
    G01500597Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals