LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 870 (Engine Mechanical) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Installation - Left >> Tools Required Torque Angle Meter

Tools Required Torque Angle Meter

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cylinder head locator dowel pins, if necessary.
  2. Inspect the cylinder head locator dowel pins for proper installation.
  3. Install the cylinder head gasket.
    Fig 1: Installing Left Cylinder Head Gasket
    G01500832Courtesy of GENERAL MOTORS CORP.
  4. Install the cylinder head.
    Fig 2: Installing Left Cylinder Head
    G01500833Courtesy of GENERAL MOTORS CORP.
  5. Install the cylinder head bolts.

    Tighten  Tighten the cylinder head bolts in sequence to 60 N.m (44 lb ft). Turn the bolts an additional 95 degrees using the J 36660-A. 

    Fig 3: Identifying Left Cylinder Head Bolts Tightening Sequence
    G01500834Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals