Diagnostic Aids
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- An intermittent CMP sensor signal may cause DTC P0340 to set. Wiggle the wiring harness with the engine running and observe the Cam Signal Missed parameter of the scan tool. If the parameter indicates anything other than 0, there is an intermittent condition. See INTERMITTENT CONDITIONS under SELF-DIAGNOSTIC SYSTEM.
- A short from the 12-volt reference circuit to the low reference circuit internally in the Camshaft Position (CMP) or Crankshaft Position (CKP) sensor can cause all three DTCs P0336, P0340, and P1345 to set.
- If the CMP sensor signal is lost while running, the engine will operate normally. If the CMP sensor signal is not present on start-up, the engine will not start.