LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 866 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Receiver Dehydrator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing the receiver dehydrator, add the specified amount of PAG oil directly to the receiver dehydrator. Refer to REFRIGERANT SYSTEM CAPACITIES  .
  2. Install new sealing washers to the receiver dehydrator.
  3. Connect the receiver dehydrator to the condenser. Refer to SEALING WASHER REPLACEMENT  .
  4. Install the receiver dehydrator lower mounting bolts.

    Tighten 

    Tighten the bolts to 6 N.m (53 lb in).

  5. Install the receiver dehydrator upper bracket bolt.

    Tighten 

    Tighten the bolt to 6 N.m (53 lb in).

    Fig 1: Installing Procedure Receiver Dehydrator
    G01498871Courtesy of GENERAL MOTORS CORP.
  6. Install the condenser. Refer to CONDENSER REPLACEMENT  .
  7. Evacuate and recharge the A/C system. Refer to REFRIGERANT RECOVERY AND RECHARGING  .
  8. Leak test the fittings of the component using J 39400-A. 
scientia non olet · About LEMON Manuals