LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 865 (Stationary Window System) >> Repair Instructions >> Window Replacement - Lift Gate (Buick) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a stationary window into the opening. Refer to URETHANE ADHESIVE INSTALLATION OF STATIONARY WINDOWS  .
  2. Connect the rear liftgate window defogger connectors to the right and left sides.
  3. Install the center light applique.
  4. Install the rear wiper motor. Refer to WIPER MOTOR REPLACEMENT--REAR .
  5. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  6. Close the liftgate.
    Fig 1: Connecting Rear Liftgate Window Defogger Connectors
    G01515733Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals