LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 864 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Door Body Side (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lower support retainer with the notch down and the retainers to the holes in the door panel.
    Fig 1: Positioning Lower Support Retainer With Notch Down And Retainers
    G01515643Courtesy of GENERAL MOTORS CORP.
  2. Install in the center pins of the retainers using a small hammer.
    Fig 2: Installing In Center Pins Of Retainers
    G01515644Courtesy of GENERAL MOTORS CORP.
  3. Position the lower support retainer with the notch down and the retainers to the holes in the door panel.
    Fig 3: Positioning Lower Support Retainer With Notch Down And Retainers
    G01515645Courtesy of GENERAL MOTORS CORP.
  4. Install in the center pins of the retainers using a small hammer.
    Fig 4: Installing In Center Pins Of Retainers
    G01515646Courtesy of GENERAL MOTORS CORP.
  5. Use a heat gun J 25070. 
  6. Position the lower flange of the rear door body side molding to the retainer support and align the tab to the notch in the retainer support.

    Important:  Do not touch the adhesive backing on the molding.

  7. Remove the protective liner from the back side of the door body side molding.
  8. Position the upper edge of the rear door body side molding retainer clips to the holes in the door panel.
  9. Install the retainer clips to the door panel by pressing in until fully seated.
  10. Install the upper edge of the rear door body side molding by applying pressure to the entire length of the molding starting at the center and working outward to ensure a maximum bond to the door panel.
    Fig 5: Installing Retainer Clips To Door Panel
    G01515647Courtesy of GENERAL MOTORS CORP.
  11. Install the screws to the rear edge of the rear door body side molding.

    Tighten 

    Tighten the screws to 6 N.m (53 lb in).

  12. Close the rear door.
    Fig 6: Installing Screws To Rear Edge Of Rear Door Body Side Molding
    G01515648Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals