Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:
- Dimension (a) is 41 mm (1.625 in) from the rear door edge to the emblem/nameplate.
- Dimension (b) is 146 mm (5.750 in) from the feature line on the door to the bottom of the emblem/nameplate.
- Warm the door surface with a heat gun J 25070
152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
- Remove the backing from the front end of the emblem/nameplate.
- Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
- Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
- Inspect the emblem/nameplate for bounding.
- Remove the tape from the area around the door emblem.