LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Automatic Transmission - Servicing - ALLISON) >> Removal & Installation >> Selector Shaft & Detent Lever >> Installation

Selector Shaft & Detent Lever: Installation

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the new detent lever (4) in position in the main housing. Rotate the detent lever to engage the park pawl apply assembly (2). Reinstall the selector shaft (5) through the selector shaft seal and through the detent lever (4). See Fig 1 .
  2. Place the nut (1) in position over the selector shaft. Push the selector shaft (5) into its final position in the main housing. Reinstall the spring pin (3) into the main housing that retains the selector shaft.
  3. Install pin to 0.33-0.35" (8.5-9.0 mm) above main housing surface. Hand tighten nut (1). Tighten the nut (1) to specification. See TORQUE SPECIFICATIONS  .
  4. Install the PNP switch. See PARK/NEUTRAL POSITION SWITCH  . Install the control valve assembly. See CONTROL VALVE BODY  .
Fig 1: Removing & Installing Selector Shaft & Detent Lever
G00096121Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals