Pressure Switch Manifold: Removal

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Individual pressure switches cannot be replaced. When any pressure switch needs replacement, the entire assembly must be replaced.

Remove the oil pan and suction filter. See INTERNAL FILTER REPLACEMENT under LUBRICATION.
Remove the 2 bolts (2). Remove the reverse signal tube (1). See Figure .
Disconnect the internal wiring harness connector from the pressure switch assembly (2). Remove 5 bolts (1). Remove the pressure switch assembly (2). See Figure .