LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Automatic Transmission - Servicing - ALLISON) >> Removal & Installation >> Control Valve Solenoids >> Removal

Control Valve Solenoids: Removal

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil pan and suction filter. See INTERNAL FILTER REPLACEMENT  under LUBRICATION. Disconnect the internal wiring harness from the solenoid being changed.
  2. Remove the 2 bolts (2) that fasten reverse signal tube (1) to the control valve assembly. Remove the reverse signal tube. See Figure .
    NOTE: When the A/B solenoid bracket (5) is removed, there are 2 sets of accumulators (3) and springs (6) which may fall from their bores. See Figure . Ensure to catch them so they are not damaged. The A/B solenoid bracket (5) MUST not be modified. Ensure the angle between the 2 bracket surfaces is 90 degrees or less. Replace the bracket if the angle is more than 90 degrees.
  3. To remove "A" or "B" solenoid, remove 3 bolts (4) and the A/B solenoid bracket (5). Remove accumulators (3) and springs (6) if they do not fall out when bracket (5) is removed. Note the position of the solenoid connector and pull the solenoid (1) or (8) out of the bore in the control valve assembly. The O-ring on the solenoid provides the resistance felt during removal.
  4. Remove the solenoid retainer (1) for the "C", "D", "E", or "F" solenoids. Note the position of the solenoid connector and pull the solenoid (3) out of the bore in the control valve assembly. The O-rings (2) provide the resistance felt during removal. See Figure .
scientia non olet · About LEMON Manuals