Control Valve Solenoids: Installation
WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate new O-rings (2) with clean transmission fluid. Install the O-rings and push the new solenoids into the control valve body bore with the wiring harness connector in the correct position.
- Reinstall the 2 accumulators (3) and springs (6) before installing the A/B solenoid bracket (5). The valve (3) goes in the bore first with the hollow end facing outward, followed by the spring (6) which goes inside the hollow portion of the valve. See Fig 1 .
- Install the solenoid retainers (1) for the "C", "D", "E", and "F" solenoids. See Fig 2 .
- Reinstall the solenoid retaining bracket (5). Install 3 bolts (4) and tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Install the reverse signal tube. Install the 2 bolts (2) that fasten reverse signal tube (1) to the control valve assembly. See Figure . Tighten the bolts to specification. See TORQUE SPECIFICATIONS . Reconnect the internal wiring harness to the solenoid. Install the oil pan and suction filter. Fill transmission with appropriate fluid to proper level. See LUBRICATION .