Shift Cable
WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure the gearshift lever and the transmission manual shaft lever are in the Park position. Raise the vehicle. Pull back the white plastic cover (1) on the center connector. See Fig 1 .
- Pull up on the center tabs of the lock button (2). See Fig 2
.NOTE: This step must be performed correctly to avoid a misadjusted cable. Do not grasp the shift cable end (2) during this procedure.
- Release the shift cable end (2) and allow the Blue spring to tension/adjust the shift cable system. See Fig 3 . Pull the White cover (3) on the shift cable end (1) back.
- Push the Natural colored lock button (2) down to engage the locking teeth on the shift cable end (1). See Fig 4 . Release the White cover (1). See Fig 5 .
- Verify the White cover (1) conceals the Natural colored lock (2). See Fig 6 . If the White cover (1) does not conceal the Natural colored lock (2), the shift cable must be readjusted.
- Test the transmission for proper shift operation. If all of the gear positions cannot be achieved, the shift cable must be readjusted.