LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 856 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (CB Series) >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
  2. Install the control valve assembly (3).
  3. Lubricate the O-ring seal (4) with power steering fluid.
  4. Install the O-ring seal (4) onto the O-ring union fitting (5).
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten 

    Tighten the fitting (5) to 75 N.m (55 lb ft).

Fig 1: Installing Control Valve Assembly
G01499335Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals