LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Rocker Arm and Push Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  When reusing the valve train components, always install the components to the original location and position.

Valve lash is net build, no valve adjustment is required.

  1. Lubricate the rocker arms and pushrod with clean engine oil.
  2. Lubricate the flange of the rocker arm bolts with clean engine oil.

    Lubricate the flange or washer surface of the bolt that will contact the rocker arm.

  3. Install the rocker arm pivot support.
    Fig 1: Installing Rocker Arm Pivot Support
    G02116386Courtesy of GENERAL MOTORS CORP.

    Important:  Make sure that the pushrod seat properly to the valve lifter sockets.

  4. Install the pushrod.
    Fig 2: Installing Pushrod
    G02116387Courtesy of GENERAL MOTORS CORP.

    Important:  Make sure that the pushrod seat properly to the ends of the rocker arms. DO NOT tighten the rocker arm bolts at this time.

  5. Install the rocker arms and bolts.
    Fig 3: Installing Rocker Arms & Bolts
    G02116388Courtesy of GENERAL MOTORS CORP.
  6. Rotate the crankshaft until the number one piston is at top dead center (TDC) of the compression stroke.

    In this position, cylinder number one rocker arms will be off lobe lift, and the crankshaft sprocket key will be at the 1:30 position.

    The engine firing order is 1, 8, 7, 2, 6, 5, 4, 3. Cylinders 1, 3, 5 and 7 are the left bank. Cylinder 2, 4, 6 and 8 are the right bank.

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. With the engine in the number one firing position, tighten the following rocker arm bolts:

    Tighten 

    • Tighten cylinders 1,2,7 and 8 exhaust valve rocker arm bolts to 30 N.m (22 lb ft).
    • Tighten cylinders 1,3,4 and 5 intake valve rocker arm bolts to 30 N.m (22 lb ft).
    Fig 4: Rotating Crankshaft 360 Degrees
    G02116389Courtesy of GENERAL MOTORS CORP.
  8. Rotate the crankshaft 360 degrees.
  9. Tighten the following rocker arm bolts:

    Tighten 

    • Tighten cylinders 3, 4, 5 and 6 exhaust valve rocker arm bolts to 30 N.m (22 lb ft).
    • Tighten cylinders 2, 6, 7 and 8 intake valve rocker arm bolts to 30 N.m (22 lb ft).
  10. Install the rocker arm cover. Refer to VALVE ROCKER ARM COVER REPLACEMENT - LEFT  or VALVE ROCKER ARM COVER REPLACEMENT - RIGHT  .
scientia non olet · About LEMON Manuals