LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt tensioner.
  2. Install the drive belt tensioner bolts.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Tighten the drive belt tensioner bolts.

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the accessory drive belt. Refer to DRIVE BELT REPLACEMENT - ACCESSORY  .
    Fig 1: Installing Procedure Drive Belt Tensioner - Accessory
    G02116299Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals