LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Cleaning and Inspection

Valve Rocker Arm Cover Cleaning and Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not use the valve rocker arm cover gasket again. Install a NEW gasket during assembly.

Remove the ignition coils before cleaning the cover in solvent. Do not submerge the ignition coils in solvent.

Do not remove the oil fill tube or crankcase vent valve grommet from the covers unless service is required.

If the oil fill tube or crankcase vent valve grommet have been removed from the rocker arm covers, install a NEW tube or grommet during assembly.

  1. Remove the ignition coil and bracket assembly, bolts, and wire harness from the left cover, if required.
    Fig 1: Removing Ignition Coil & Bracket Assembly, Bolts & Wire Harness From Left Cover
    G02116835Courtesy of GENERAL MOTORS CORP.
  2. Remove the ignition coil and bracket assembly, bolts, and wire harness from the right cover, if required.
    Fig 2: Removing Ignition Coil & Bracket Assembly, Bolts & Wire Harness From Right Cover
    G02116836Courtesy of GENERAL MOTORS CORP.
  3. Inspect the tube for a loose fit or damage.
  4. Remove the oil fill cap and tube from the right cover, if required.
    Fig 3: Removing Oil Fill Cap & Tube From Right Cover
    G02116837Courtesy of GENERAL MOTORS CORP.
  5. Remove the gaskets (1) from the covers.
  6. Remove the cover mounting bolts, with grommets.

    Cover mounting bolts and grommets that are not damaged may be used again during assembly.

  7. Clean the covers in solvent.
    Fig 4: Removing Gaskets From Covers
    G02116838Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SAFETY GLASSES CAUTION in Cautions and Notices.
  8. Dry the covers with compressed air.
  9. Inspect the ventilation system passages for restrictions.
  10. Inspect the gasket grooves for damage.
  11. Inspect the coil bracket threaded bolt holes for damage or debris.
    Fig 5: Inspecting Coil Bracket Threaded Bolt Holes For Damage
    G02116839Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals