LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft and Bearings Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cleaning Crankshaft With Solvent
G02116700Courtesy of GENERAL MOTORS CORP.

Important:  Use care when handling the crankshaft. Avoid damage to the bearing surfaces or the lobes of the crankshaft position reluctor ring. Damage to the teeth of the crankshaft position reluctor ring may effect On-Board Diagnostics (OBD) II system performance.

  1. Clean the crankshaft with solvent.
  2. Thoroughly clean all oil passages and inspect for restrictions or burrs.
    CAUTION: Refer to SAFETY GLASSES CAUTION in Cautions and Notices.
  3. Dry the crankshaft with compressed air.