LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 854 (Transfer Case - NVG 236/246-NP8) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transfer case shield, if equipped.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the transfer case shield bolts, if equipped.

    Tighten 

    Tighten the bolts to 20 N.m (15 lb ft).

  3. Lower the vehicle.
    Fig 1: Installing Transfer Case Shield & Bolts
    G01456612Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals