Scan Tool Data List: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The electronic suspension control (ESC) scan tool data list contains all the electronic suspension control system related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The column, Data List, indicates the location of the parameter within the scan tool menu selections.

Use the ESC scan tool data list as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with the Diagnostic System Check. Use the ESC scan tool data list only after the following is determined:

The ESC Diagnostic System Check is complete.
The on board diagnostics are operating correctly.
No diagnostic trouble codes (DTCs) are displayed.

The typical scan tool data values are an average of the displayed values recorded from normally operating vehicles. The typical scan tool data values are intended to represent what a normally functioning system would display with certain preliminary settings. The values you get may vary slightly due to a low battery charge or other reasons. But the values should be very close.

Use only the parameters listed in the tables for diagnosis. If a scan tool reads other parameters, the values are not recommended for use in diagnosis.

Refer to SCAN TOOL DATA DEFINITIONS for further detailed information.