LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 850 (Suspension Control System - Suspension Damping) >> Diagnostic Information and Procedures >> Scan Tool Data List >> Cycle Outputs

Cycle Outputs

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

A scan tool may be used in order to command the suspension damper solenoids and SERVICE RIDE CONTROL message ON or OFF. This can be very helpful in determining if a certain portion of a circuit or a component is in working order.

The following tests are available under the Special Functions selection. The following can be commanded ON or OFF:

Fig 1: Electronic Suspension Control (ESC) Scan Tool Data List
G01455638Courtesy of GENERAL MOTORS CORP.