LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Automatic Transmission Servicing) >> Removal & Installation >> Case Extension Housing >> Installation

Case Extension Housing: Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed install the drive axle seal. See Figure . Install the case extension housing with the axle seal and the O-ring.
  2. Install the case extension housing bolts. Tighten the case extension housing bolts to specification. See TORQUE SPECIFICATIONS  . Install the vehicle speed sensor. See VEHICLE SPEED SENSOR  .
  3. Install the transaxle brace to engine bolts. See TRANSAXLE BRACE  . Install the right drive axle to the transaxle. See appropriate article in DRIVE AXLES. Lower the vehicle.
  4. Connect the negative battery cable. Fill transaxle with appropriate fluid to proper level. See LUBRICATION  . Inspect for fluid leaks.
scientia non olet · About LEMON Manuals