LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 845 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (Regular) >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (4) if removed from the pump housing (1).
  2. Lubricate the new rectangular section seal (2) with power steering fluid.
  3. Install the rectangular section seal (2) onto the control valve assembly (3).
  4. Install the control valve assembly (3).
    Fig 1: Installing Control Valve Assembly
    G01454933Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals