LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 840 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Replacement - Auxiliary >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right rear quarter trim panel. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER - RIGHT (UTILITY) or TRIM PANEL REPLACEMENT - REAR QUARTER - RIGHT (SUBURBAN) in Interior Trim.
  2. Disconnect the electrical connector from the blower motor resistor.
  3. Remove the retaining screws from the blower motor resistor.
  4. Remove the blower motor resistor (1) from the vehicle.
    Fig 1: Removing Blower Motor Resistor - Auxiliary
    G01454440Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals