LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 839 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Rear (Bench) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions: 
  • More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog. 
  • To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch mu be fully seated and be retained in the buckle until purposely released. 
  1. Remove the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR (50/50 SPLIT - 60/40 SPLIT) or SEAT BACK COVER AND PAD REPLACEMENT - REAR (BENCH) in SEAT SYSTEM s.
  2. Remove the seat belt retractor bolt (1) from the seat frame.
  3. Remove the retractor.
    Fig 1: Removing Seat Belt Retractor Bolt From Seat Frame
    G01459731Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals