LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 839 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear (Tahoe/Yukon/Escalade/Suburban) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door sill plate. Refer to DOOR SILL PLATE REPLACEMENT - FRONT or DOOR SILL PLATE REPLACEMENT - REAR in INTERIOR TRIM .
  2. Remove the lower anchor bolt from bodyside panel.
  3. Remove the third pillar trim panel. Refer to TRIM REPLACEMENT - THIRD PILLAR (TAHOE / YUKON / ESCALADE / SUBURBAN) or TRIM REPLACEMENT - THIRD PILLAR (AVALANCHE / ESCALADE EXT) in INTERIOR TRIM .
  4. Route the belt through trim panel.
  5. Remove the bolt from the upper guide.
  6. Remove the bolt from the retractor.
  7. Remove the seatbelt anchor bolt cover.
  8. Remove the floor anchor bolt.
  9. Remove the assembly from the vehicle.
scientia non olet · About LEMON Manuals