LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 839 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear (Avalanche/Escalade EXT) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fold the rear seat down.
  2. Remove the rear floor door sill. Refer to DOOR SILL PLATE REPLACEMENT - REAR in INTERIOR TRIM .
  3. Remove the rear removable glass panel.
  4. Remove the seat belt anchor cover.
  5. Remove the third pillar trim panel. Refer to TRIM REPLACEMENT - THIRD PILLAR (TAHOE / YUKON / ESCALADE / SUBURBAN) or TRIM REPLACEMENT - THIRD PILLAR (AVALANCHE / ESCALADE EXT) in INTERIOR TRIM .
  6. Remove the seat belt anchor retaining bolt.
    Fig 1: Removing Seat Belt Anchor Retaining Bolt
    G01459719Courtesy of GENERAL MOTORS CORP.
  7. Route the seat belt through the opening in the pillar trim panel.
  8. Remove the seat belt retractor bolt.
  9. Remove the rear seat belt assembly from the vehicle.
scientia non olet · About LEMON Manuals