LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 839 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - No. 2 Rear (60/40 Split - 50/50 Split) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the buckle to the seat frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the buckle bolts.

    Tighten 

    1. Tighten the bolts to 53 N.m (39 lb ft).
    Fig 1: Installing Buckle To Seat Frame
    G01459691Courtesy of GENERAL MOTORS CORP.
  3. Connect the seat cushion cover by joining the cushion J-strips.
  4. Install the handle mounting screws.

    Tighten 

    1. Tighten the screws to 7 N.m (61 lb in).
    Fig 2: Installing Handle Mounting Screws
    G01459692Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals