LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 838 (Seat System) >> Repair Instructions >> Head Restraint Replacement (Non-Cadillac) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the head restraint (1) to the full up position.
  2. Insert a paper clip or a similar tool in the hole at the side edges of the head restraint retainers.
  3. Press in on the tool in order to release the retainer clips (2).
  4. Lift the head restraint from the retainers.
    Fig 1: Removing Head Restraint From Retainers
    G01459209Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals