LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 838 (Seat System) >> Repair Instructions >> Head Restraint Replacement (Cadillac) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the head restraint by pushing down on restraint until the restraint is fully seated.
  2. To ensure the head restraint is fully seated pull the head restraint up to the full upward position. The head restraint must not come off the restraint rod.
    Fig 1: Installing Head Restraint
    G01459208Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals