LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 838 (Seat System) >> Repair Instructions >> Head Restraint Release Cable Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR (50/50 SPLIT - 60/40 SPLIT)  or SEAT BACK COVER AND PAD REPLACEMENT - REAR (BENCH)  .
  2. Unclip the cable end (1) off of the seat back latch.
  3. Remove the cable from the seat back latch.
    1. 3.1. Squeeze the cable retainer tabs (2) together.
    2. 3.2. Pull the cable from the seat back latch.
    Fig 1: Uncliping Cable End Off Of Seat Back Latch
    G01459267Courtesy of GENERAL MOTORS CORP.
  4. Unclip the cable end (1) from the head restraint release mechanism.
  5. Remove the cable from the head restraint release mechanism.
    1. 5.1. Squeeze the cable retainer tabs (2) together.
    2. 5.2. Pull the cable from the head restraint release mechanism.
    Fig 2: Uncliping Cable End From Head Restraint Release Mechanism
    G01459268Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals