Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Use the J25070 in order to heat the molding and the surrounding sheet metal to 82-93°C (180-200°F).
- Remove the roof joint molding.
Use a flat bladed tool in order to pry off the molding between the sealer and the joint. Use pliers or a similar tool in order to handle the hot molding and pull the molding loose. The molding and the sealer should come off in 1 piece.
Do not damage the paint on the cab.
- Clean the joint in order to remove any remaining sealer. Sealer could interfere with the fit of the replacement molding.