LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 835 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Side Door Lower (Z-71) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear end cap to the vehicle.
  2. Install the 1 push-pin.
  3. Install the 2 rivets to the bottom of the end cap.
  4. Install the clip (1) to the rear end cap.
    5. Fig 1: Installing Rear Door Body Lower Molding (Z-71)
    G01458438Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals