LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 835 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Body Side - Lower Rear (Z-71) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the molding to the vehicle.
    2. Fig 1: Installing Rear Body Side Lower Rear (Molding Z-71)
    G01458446Courtesy of GENERAL MOTORS CORP.
  2. Install the 3 push-pins to the lower rear body molding.
scientia non olet · About LEMON Manuals