LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 835 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Fender Rear (Z-71) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front end cap to the vehicle.
  2. Install the 2 push-pins to the front of the end cap.
    3. Fig 1: Installing Front Fender Rear Molding (Z-71)
    G01458428Courtesy of GENERAL MOTORS CORP.
  3. Install the rivet.
scientia non olet · About LEMON Manuals