Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important : Be careful not to scratch or chip the paint.

Heat the body side molding using a heat gun.
Hold the heat gun approximately 152 mm (6 in) from the surface.

Apply heat using a circular motion for about 30 seconds.

Fig 1: Removing Door Body Side Molding (Tahoe/Yukon)

Courtesy of GENERAL MOTORS CORP.

Starting from one end of the molding, peel off the molding from the panel surface using a flat-bladed tool.
Remove all adhesive from the body panel using a 3M™ scotch brite molding adhesive remover disk P/N 07501 or equivalent.