LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Automatic Transmission - 4L80-E/4L85-E (Service & Replacement)) >> Repair Instructions >> Filler Tube and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Yukon XL, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission fill tube seal.
  2. Install the fill tube.
  3. Remove the drain pan from under the transmission.
    Fig 1: Installing Transmission Fill Tube Seal
    G02112232Courtesy of GENERAL MOTORS CORP.
  4. Install the fill tube bracket nut.
  5. Lower the vehicle.
    NOTE: Refer to FASTENER NOTICE  i  in Cautions and Notices.
  6. Install the oil level indicator.

    Tighten 

    Tighten the nut to 47 N.m (35 lb ft).

  7. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to TRANSMISSION FLUID CHECKING PROCEDURE  .
    Fig 2: Installing Fill Tube Bracket Nut
    G02112233Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals