LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Automatic Transmission - 4L80-E/4L85-E (Service & Replacement)) >> Diagnostic Information and Procedures >> Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096) >> Machine Set-up

Machine Set-up

WARNING: This page is about a different car, the 2003 GMC Yukon XL, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Verifying Main Power Switch Is OFF
G02112091Courtesy of GENERAL MOTORS CORP.
  1. Verify that the main power switch (1) is in the OFF position.
  2. Place the main function switch (2) in the IDLE position.
    Fig 2: Connecting To Vehicle 12 V DC Power Source
    G02112092Courtesy of GENERAL MOTORS CORP.
  3. Connect J 45096  to the vehicle 12 V DC power source by connecting the red battery clip to the positive, +, battery post on the vehicle and connect the negative lead to a known good chassis ground.
  4. Turn the main power switch to the ON position.
    Fig 3: Turning Main Power Switch To ON
    G02112093Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not overfill the supply vessel. Damage to the unit may result. To verify the fluid level, view the LCD screen display while filling the unit, to ensure the fluid level does not exceed 30 L (32 qt).
  5. Fill the supply tank with DEXRON®III/Mercon®, or equivalent, through the fill port.
  6. Install and tighten the fill cap.
    Fig 4: Connecting Shop Air Supply Hose To Quick-Disconnect
    G02112094Courtesy of GENERAL MOTORS CORP.
  7. Connect a shop air supply hose to the quick-disconnect on the rear panel marked SUPPLY AIR.
scientia non olet · About LEMON Manuals