LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 831 (Transfer Case - BW 4482-Nr4) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the J 45756  , install a NEW output shaft seal.
  2. Install the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - REAR in Propeller Shaft.
  3. Check the fluid level. Add fluid if necessary.
  4. Install the transfer case shield, if equipped. Refer to TRANSFER CASE SHIELD REPLACEMENT .
    Fig 1: Installing Rear Output Shaft Seal
    G01456515Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals