LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 827 (Body Rear End) >> Repair Instructions >> Wiring Harness Replacement - Door (Cargo Door) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel. Refer to TRIM PANEL REPLACEMENT - REAR DOOR  .
  2. Remove the wiring contact screws.
  3. Disconnect the door wiring contact connector(s).
  4. Disconnect the window defogger wiring connectors.
  5. Disconnect the power door lock actuator connector (RHS only).
  6. Disconnect the door ajar switch connectors.
  7. Disconnect the key switch connector (RHS only).
  8. Remove the wiring harness clips.
  9. Remove the wiring harness from the door.
    10. Fig 1: Removing Wiring Harness From Door
    G01459517Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals