LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 822 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Avalanche) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the headlamp switch is in the OFF position.
  2. Remove the rear compartment cover assembly.
  3. Fig 1: Removing Procedure High Mounted Stop Lamp (Avalanche) (1 Of 2)
    G01457636Courtesy of GENERAL MOTORS CORP.
  4. Remove the cargo box bridge center bar. Refer to PANEL REPLACEMENT - CARGO BOX BRIDGE CENTER (AVALANCHE) or PANEL REPLACEMENT - CARGO BOX BRIDGE CENTER (ESCALADE EXT) in EXTERIOR TRIM .
  5. Remove the panel assembly from the vehicle.
  6. Fig 2: Removing Procedure High Mounted Stop Lamp (Avalanche) (2 Of 2)
    G01457637Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connector from the high mounted stop lamp. Refer to HIGH MOUNTED STOP LAMP REPLACEMENT (UTILITY)  or HIGH MOUNTED STOP LAMP REPLACEMENT (CADILLAC)  or HIGH MOUNTED STOP LAMP REPLACEMENT (ESCALADE EXT)  or HIGH MOUNTED STOP LAMP REPLACEMENT (AVALANCHE)  .