LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 822 (Lighting Systems) >> Repair Instructions >> Fog Lamp Bulb Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb to the rear fog lamp assembly by inserting the bulb and twisting the bulb clockwise.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the rear fog lamp lens (1) retaining screws (2).

    Tighten 

    Fig 1: Installing Procedure Fog Lamp - Rear
    G01457601Courtesy of GENERAL MOTORS CORP.

    Tighten the screws (2) to 2 N.m (18 lb in).

  3. Inspect the operation of the rear fog lamp.
scientia non olet · About LEMON Manuals